Verifying Cli Usage - Alcatel-Lucent OmniSwitch AOS Release 6 Manual

Verifying CLI Usage

4
Press the spacebar <sp> key to execute the filter option. The following will display.
Enter filter pattern: *vlan*
8193 dot1qBase
8194 dot1qVlan
8195 dot1qVlanCurrentTable
8196 dot1qVlanStaticTable
8197 vlanMgrVlanSet
8198 vlanTable
8199 vpaTable
9217 vCustomRuleTable
9218 vDhcpGenericRuleTable
9219 vDhcpMacRuleTable
More? [next screen <sp>*, next line <cr>*, filter pattern </>*, quit <q>]
The screen displays 10 table rows, each of which contain the text pattern "vlan" Alcatel-Lucent's CLI uses
a single level command hierarchy. (The screen rows shown above and below the table are not counted as
part of the 10 rows.) If you want to display the rows one line at a time, press Enter instead of the space bar
key. To exit the table, type the "q" character and the CLI will exit the
system prompt.
Verifying CLI Usage
To display information about CLI commands and the configuration status of your switch, use the show
commands listed here:
show session config
show alias
show prefix
show history
show more
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide. Additional information can also be found in
page 6-24
Displays session manager configuration information (e.g., default
prompt, banner file name, and inactivity timer).
Lists all current commands defined by the use of the
mand.
Shows the command prefix (if any) currently stored by the CLI. Prefixes
are stored for command families that support the prefix recognition fea-
ture.
Displays commands you have recently issued to the switch. The com-
mands are displayed in a numbered list.
Shows the enable status of the more mode along with the number of
lines specified for the screen display.
"Using "Show" Commands" on page
OmniSwitch AOS Release 6 Switch Management Guide
vlan
vlan
vlan
vlan
vlan
vlan
vlan
vlan
vlan
vlan
more mode and return you to the
alias
Using the CLI
CLI com-
6-4.
July 2010