In This Chapter - Alcatel-Lucent OmniSwitch AOS Release 6 Manual

4 Configuring Network Time
Network Time Protocol (NTP) is used to synchronize the time of a computer client or server to another
server or reference time source, such as a radio or satellite receiver. It provides client time accuracies
within a millisecond on LANs, and up to a few tens of milliseconds on WANs relative to a primary server
synchronized to Universal Coordinated Time (UTC) (via a Global Positioning Service receiver, for exam-
ple).

In This Chapter

This chapter describes the basic components of the OmniSwitch implementation of Network Time Proto-
col and how to configure it through Command Line Interface (CLI). CLI commands are used in the
configuration examples; for more details about the syntax of commands, see the OmniSwitch CLI Refer-
ence Guide.
Configuration procedures described in this chapter include:
•
Enabling the NTP client and selecting the NTP mode. See
on page 4-9.
•
Selecting an NTP server for the NTP client and modifying settings for communicating with the server.
See "Configuring NTP Servers" on page
•
Configuring the NTP server on the OmniSwitch. See
on page 4-11.
•
Enabling authentication in NTP negotiations. See
OmniSwitch AOS Release 6 Switch Management Guide
Protocol (NTP)
"Configuring the OmniSwitch as a Client"
4-10.
"Configuring the OmniSwitch as an NTP Server"
"Using Authentication" on page
July 2010
4-12.
page 4-1