Table of Contents
Advertisement
Prestige 100L IDSL Router
Press Space Bar to Toggle.
The following table describes how to configure your TCP/IP filter rule.
FIELD
Active
IP Protocol
IP Source Route
Destination: IP
Address
Destination: IP
Mask
Destination: Port #
6-8
Menu 21.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 6
Destination: IP Addr= 0.0.0.0
Source: IP Addr= 0.0.0.0
TCP Estab= No
More= No
Action Matched= Drop
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Figure 6-3
Menu 21.1.1
Table 6-4
TCP/IP Filter Rule Menu Fields
This field activates/deactivates the filter rule.
Protocol refers to the upper layer protocol, e.g., TCP is 6,
UDP is 17 and ICMP is 1. This value must be between 0
and 255.
If Yes, the rule applies to packet with IP source route
option; else the packet must not have source route option.
The majority of IP packets do not have source route.
Enter the destination IP Address of the packet you wish to
filter. This field is disregarded if it has a 0.0.0.0 value.
Enter the IP mask to apply to the Destination: IP Addr.
Enter the destination port of the packets that you wish to
filter. The range of this field is 0 to 65535. This field is
disregarded if it has a 0 value.
IP Source Route= No
IP Mask= 0.0.0.0
Port #= 137
Port # Comp= Equal
IP Mask= 0.0.0.0
Port #=
Port # Comp= None
Log= None
TCP/IP Filter Rule
–
DESCRIPTION
OPTION
Yes/No
0 to 255
Yes/No
IP address
IP address
0 to 65535
Filters
Advertisement
Table of Contents
Troubleshooting
