Quitting The Forwarding Function; Forwarding Mark - Savin 2018 Operating Instructions Manual

Kir-C2-ENcombine_F_FM.book Page 78 Friday, September 19, 2003 3:03 PM
Key Operator Setting
Note
❒ If there is an End Receiver already
programmed, a receiver name is
shown. If you want to change the
receiver, press the { { { { Clear/Stop} } } }
key and proceed to step F.
❒ To cancel Forwarding, press the
{ { { { Cancel} } } } key and proceed to
G
step .
F F F F
Specify an End Receiver using the
Quick Dial key or searching by
the destination list, and then
press the { { { { OK} } } } key.
See p.38 "Searching for a Destina-
tion", Facsimile Reference <Basic
Features>.
G G G G
Press the { { { { User Tools/Counter} } } } key.
The standby display appears.

Quitting the forwarding function

7
A A A A
Press the { { { { User Tools/Counter} } } } key.
User Tools/
Counter
On Hook Dial On Hook Dial
B B B B
Select [Fax Features] using { { { { U U U U } } } } or
{ { { { T T T T } } } } , and then press the { { { { OK} } } } key.
C C C C
Select [Key Operator Tools] using
{ { { { U U U U } } } } or { { { { T T T T } } } } , and then press the
{ { { { OK} } } } key.
78
Clear
Modes
Clear/Stop
ABC DEF
AAN115F
D D D D
Select [Forwarding] using { { { { U U U U } } } } or
{ { { { T T T T } } } } , and then press the { { { { OK} } } } key.
E E E E
Select [Off], using { { { { U U U U } } } } or { { { { T T T T } } } } , and
then press the { { { { OK} } } } key.
F F F F
Press the { { { { User Tools/Counter} } } } key.
The standby display appears.

Forwarding Mark

You can print a Forwarding Mark on
the receiver's messages that have
been forwarded.
The receiver can distinguish between
forwarded messages and usual recep-
tions.
Note
❒ You can specify whether or not to
print a Forwarding Mark in the
User Parameters. See p.80 "User
Parameters" (switch 02, bit 0).