User Transmission - Savin 2018 Operating Instructions Manual

Kir-C2-ENcombine_F_FM.book Page 5 Friday, September 19, 2003 3:03 PM

User Transmission

This function allows you to check
each user or department's transmis-
sion history. To use the function, you
need to program a user code (eight
digits max.) for each user or depart-
ment, to be entered before transmis-
sion. See General Settings Guide.
If a user code set with an e-mail ad-
dress is specified, a transmission re-
sult e-mail can be sent.
Note
❒ You can program codes of up to 8
digits for a maximum of 50 users
and/or departments.
❒ You can enter user codes or names
into various lists or reports.
❒ You can program transmission op-
erations in User Function key. User
Function key let you skip steps B
and C.
❒ When you send an Internet Fax
document using the user code with
e-mail address programmed and
"Regist. as Sender" set to [On], the
following sender name appears on
the e-mail received at the other
end. For details about settings, see
"User Code (MFP)", General Set-
tings Guide.
• When User Name is programmed
in the user code:
User Name <E-mail address
programmed in the user code>
• When User Name is not pro-
grammed in the user code:
E-mail address programmed in
the user code
A A A A
Place the original, and then select
desired scan settings.
Reference
p.15 "Placing Originals", Fac-
simile Reference <Basic Features>
p.29 "Scan Settings", Facsimile
Reference <Basic Features>
B B B B
Press [TX Mode].
C C C C
Select [TX by User Code] using { { { { U U U U } } } }
or { { { { T T T T } } } } , and then press the { { { { OK} } } }
key.
D D D D
Using the number keys enter a
user code (up to eight characters).
Note
❒ Entered character is shown by *.
❒ If you enter a wrong code, press
the { { { { Clear/Stop} } } } key, and then
try again.
❒ To cancel the operation, press
the { { { { Cancel} } } } key. The display re-
turns to that of step C.
User Transmission
1
5