Korg MMT RADIAS Owner's Manual page 99

Reverse
Play from the last step (the step number specified by
"Last Step") in reverse.
Reverse (Last Step=16)
Step Step Step
16 15 14
Run Mode=Loop
Alt1/Alt2
Alternately play in Forward and Reverse directions. Alt
1 immediately changes direction at the end points, so the
first step and last steps are played only once per loop.
Alt 2 plays the first step and the last step on both the way
up and on the way down, so these steps will be played
twice per loop.
Alt1 (Last Step=16)
Step Step
01 02
Run Mode
Step Step
=Loop
01 02
Alt2 (Last Step=16)
Step Step
01 02
Run Mode
=Loop
Step Step
01 02
Playback is always in the Forward direction for
Motion Rec.
3: RunMode
Specifies the loop setting for playback.
OneShot
The sequence will play for only one cycle, and will main-
tain the value of the last step.
Loop
The sequence will play as a loop, using the sequence
type specified by "Seq Type."
When you're using the Motion Rec function, or
"KeySync" is off, playback is always in the Loop
mode.
4: KeySync
Specifies how the sequence will be reset when note-on
occurs (i.e., when a key is played).
Off
The sequence will not be reset when note-on occurs.
Timbre
The sequence will be reset when the first note-on occurs
for a timbre from a condition of all keys being released.
In the case of a program for which different regions of
the keyboard play different timbres (i.e., a split pro-
gram), the reset will occur for the timbre that was played
by the note-on.
Voice
The sequence will be individually reset by each new
note-on that occurs.
Step Step Step
03 02 01
Step Step
15 16
Step
15
Step Step
15 16
Step Step
15 16
[OneShot, Loop]
[Off, Timbre, Voice]
If both the modulation sequencer and the arpeg-
giator are on, you should set this parameter to Off
or Timbre. If this is set to Voice, the sequence will
be reset each time the arpeggiator generates a
note. If you set this to Timbre, the sequence will be
reset each time a chord change occurs.
5: Resolutn (Resolution)
Specifies the playback speed of the sequence relative to
the tempo (MIDI clock) specified by the [TEMPO] knob.
The sequence will advance by one step for each note val-
ue you specify here, relative to the tempo. For example
if you set this to 1/4, the sequence will advance one
step for each quarter note.
P12–2...4: SEQ1...SEQ3
1: Knob
Selects the parameter that will be recorded in the modu-
lation sequencer.
None
The modulation sequence will do nothing.
Pitch
The modulation sequence will modify the overall pitch
of the sounding oscillators over a range of ±24 semi-
tones.
Other
The modulation sequence will modify the parameter as-
signed to a specific panel knob over a range of ±63 (±24
for OSC2 Sem).
If the same parameter is assigned to more than one
sequence, an "*" is shown at the right. In this case,
assignments will take priority in the order of
SEQ3, SEQ2, and SEQ1.
2: Motion
Specifies how the recorded values will change when the
sequence is played.
(Smooth)
The change will be continuous, with the values recorded
at each step connected by straight lines.
1 2 3 4 5 6 7
Steps
3. Synth Parameters
[ 31/48... 1/1]
[None, Pitch...Pch6Int]
[ ,
8 9 10 11 12 13 14 15 16
]
93