Korg MMT RADIAS Owner's Manual page 59

press this key repeatedly, the note data for the notes you are holding down will be entered for the
corresponding steps.
9
Press the [TYPE/STEP REC] button or the [EXIT/NO] button to stop recording.
In this example we've stopped recording at step 5, so the "Last Step" of step sequencer 1 will auto-
matically be set to 4.
When you execute step recording, the following parameters will be automatically updated in cer-
tain cases.
"Last Step" (the valid length of the step sequence): The Last Step number will be updated if
recording increases the number of steps.
"Seq Base Note" (the note number that will be the pitch reference for step sequence playback):
This will be updated to the lowest note number between step 1 and the last step.
Checking the recorded data
1
Turn on the ARPEGGIATOR/STEP SEQUENCER [ON] button, and press the C4 key.
The phrase will play at the recorded pitch.
2
Press the D4 key.
The phrase will begin from D4.
In this way, the recorded phrase will change depending on the key you press.
If the phrase does not transpose, turn the P15–1: STEP SEQ – COMN tab page "Transpose" setting
On.
Editing each step (STEP SEQ – TRIGGER)
You can view the locations at which the step sequencer will sound, and edit the trigger status of each step.
You can also use the 16 KEYS [1]–[16] keys to edit.
This specifies whether the note data recorded at each step will sound.
1
Go to the P15–2: STEP SEQ2 – TRIG tab page.
2
Use "NoteSel" to specify the note number you want to
edit.
TRIGGER: The display indicates the "Trigger" on/off
status of each step.
C-1–G9: This specifies the note number. If the specified
note number is recorded in the step, a
shown at that step in the display. However if "Trigger"
is off for that step, a – symbol is shown.
Drum 01–Drum 16: If a drum kit is assigned to the timbre, you can specify the drum instrument. If
the specified drum instrument will play for that step, a
play. If a drum kit is not assigned, you can't select this.
3
Use the cursor buttons to move to the step you want to
edit. You can move rapidly by holding down a cursor
button.
4
Use the [PROGRAM/VALUE] dial to edit the trigger
status.
means that this step will sound.
– means that this step will not sound.
symbol is
symbol is shown at that step in the dis-
Program parameter editing
53