Korg MMT RADIAS Owner's Manual page 142

Effect guide
Spread
Sets the width of the stereo image of the effect sound.
☞p.132 LCR Delay "Spread"
20. St.Chorus (Stereo Chorus)
This effect adds thickness and warmth to the sound by
modulating the delay time of the input signal. You can
add spread to the sound by offsetting the phase of the
left and right LFOs from each other.
Stereo In - Stereo Out
Left
LEQ
Trim
LEQ
Trim
Right
LFO
Dry/Wet
Sets the balance between the effect and dry sounds.
Mod Depth (Modulation Depth)
Sets the depth of LFO modulation.
LFO Freq (LFO Frequency)
Sets the LFO speed. Increasing this value will result in a
faster frequency.
LFOSpread (LFO Spread)
Sets the LFO phase difference between the left and right.
PreDelayL, PreDelayR
Sets the delay times for the left and right channels.
Trim
Sets the input level.
LoEQGain (Low EQ Gain)
Sets the gain of Low EQ.
HiEQGain (High EQ Gain)
Sets the gain of High EQ.
136
[000...127]
Dry / Wet
HEQ
Chorus
HEQ
Chorus
Dry / Wet
LFO Spread
[Dry, 99:1...1:99, Wet]
[000...127]
[0.01...100.0Hz]
[–180...180°]
[00.0...50.0msec]
[000...127]
[–15.0...+15.0dB]
[–15.0...+15.0dB]
21. Ensemble
This effect produces a deep and spacious ensemble
sound.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
+
Ensemble
Right
LFO
Dry/Wet
Sets the balance between the effect and dry sounds.
Mod Depth (Modulation Depth)
Sets the depth of LFO modulation.
Speed
Sets the LFO speed.
22. St.Flanger
(Stereo Flanger/Comb Filter)
This effect gives a significant swell and movement of
pitch to the sound. It is more effective when applied to a
sound with a lot of harmonics. This is a stereo flanger.
You can add spread to the sound by offsetting the phase
of the left and right LFOs from each other. This effect can
also be used as a comb filter.
Stereo In - Stereo Out
Left
Flanger
Flanger
Right
LFO LFO Shape
Dry/Wet
Sets the balance between the effect and dry sounds.
Type
Switches the effect between flanger and comb filter.
Delay
Sets the delay time in millisecond steps when "Type" is
set to Flanger.
If this parameter is assigned to "Edit1," "Edit2," or
"Edit," setting "Type" to Comb will switch the as-
signment to Cutoff.
Cutoff (Cutoff Frequency)
When "Type" is set to Comb, this sets the cutoff frequen-
cy of the comb filter.
Dry / Wet
Dry / Wet
[Dry, 99:1...1:99, Wet]
[000...127]
[001...127]
Dry / Wet
Feedback
High Damp (Type: Flanger)
Dry / Wet
LFO Spread
[Dry, 99:1...1:99, Wet]
[Flanger, Comb]
[00.0...30.0msec]
[000...127]