Debug Platform Ip Wccp - Cisco Catalyst 3120 Command Reference Manual

debug platform ip wccp

debug platform ip wccp
Use the debug platform ip wccp privileged EXEC command to enable debugging of Web Cache
Communication Protocol (WCCP). Use the no form of this command to disable debugging.
This command is available only if your switch is running the IP services feature set.
Syntax Description acl
event
odm
trace
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX
Usage Guidelines
The undebug platform ip wccp command is the same as the no debug platform ip wccp command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3120 for HP Command Reference
B-42
debug platform ip wccp {acl | event | odm | trace}
no debug platform ip wccp {acl | event | odm | trace}
Display WCCP access control lists (ACLs).
Display WCCP event debug messages.
Display WCCP OD merge VMRs.
Trace WCCP execution.
Modification
This command was introduced.
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
Description
Displays information about the types of debugging that are
enabled.
OL-12248-01