Ip Arp Inspection Trust - Cisco Catalyst 3120 Command Reference Manual

Catalyst blade switch 3120 for hp command reference

Hide thumbs Also See for Catalyst 3120:

Table of Contents

Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

ip arp inspection trust

Use the ip arp inspection trust interface configuration command on the switch stack or on a standalone

switch to configure an interface trust state that determines which incoming Address Resolution Protocol

(ARP) packets are inspected. Use the no form of this command to return to the default setting.

This command is available only if your switch is running the IP services feature set.

Syntax Description

This command has no arguments or keywords.

The interface is untrusted.

Command Modes

Interface configuration

Command History

Usage Guidelines

The switch does not check ARP packets that it receives on the trusted interface; it simply forwards the

For untrusted interfaces, the switch intercepts all ARP requests and responses. It verifies that the

intercepted packets have valid IP-to-MAC address bindings before updating the local cache and before

forwarding the packet to the appropriate destination. The switch drops invalid packets and logs them in

the log buffer according to the logging configuration specified with the ip arp inspection vlan logging

global configuration command.

This example shows how to configure a port to be trusted:

Switch(config)# interface gigabitethernet1/0/1

Switch(config-if)# ip arp inspection trust

You can verify your setting by entering the show ip arp inspection interfaces interface-id privileged

EXEC command.

ip arp inspection trust

no ip arp inspection trust

Modification

This command was introduced.

Cisco Catalyst Blade Switch 3120 for HP Command Reference

ip arp inspection trust