Mac Access-List Extended - Cisco Catalyst 3120 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

mac access-list extended

Use the mac access-list extended global configuration command on the switch stack or on a standalone
switch to create an access list based on MAC addresses for non-IP traffic. Using this command puts you
in the extended MAC access-list configuration mode. Use the no form of this command to return to the
default setting.
name
Syntax Description
Defaults
By default, there are no MAC access lists created.
Command Modes
Global configuration
Command History Release
12.2(40)EX
Usage Guidelines
MAC named extended lists are used with VLAN maps and class maps.
You can apply named MAC extended ACLs to VLAN maps or to Layer 2 interfaces; you cannot apply
named MAC extended ACLs to Layer 3 interfaces.
Entering the mac access-list extended command enables the MAC access-list configuration mode.
These configuration commands are available:
•
•
•
•
•
For more information about MAC extended access lists, see the software configuration guide for this
release.
OL-12248-01
mac access-list extended name
no mac access-list extended name
Assign a name to the MAC extended access list.
Modification
This command was introduced.
default: sets a command to its default.
deny: specifies packets to reject. For more information, see the
configuration) MAC access-list configuration command.
exit: exits from MAC access-list configuration mode.
no: negates a command or sets its defaults.
permit: specifies packets to forward. For more information, see the
configuration) command.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
mac access-list extended
deny (MAC access-list
permit (MAC access-list
2-243