Debug Fastethernet - Cisco Catalyst 3120 Command Reference Manual

Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands

debug fastethernet

Use the debug fastethernet privileged EXEC command to enable debugging of the Ethernet
management port. Use the no form of this command to disable debugging.
Syntax Description
af
events
packets
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX
Usage Guidelines The undebug fastethernet {af | events | packets} command is the same as the no debug fastethernet
{af | events | packets} command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
show controllers
ethernet-controller
fastethernet
OL-12248-01
debug fastethernet {af | events | packets}
no debug fastethernet {af | events | packets}
Display Ethernet management port software-address-filter debug messages.
Display Ethernet management port event debug messages.
Display Ethernet management port packet debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays information about the Ethernet management port.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
debug fastethernet
B-9