Cisco Catalyst 3120 Command Reference Manual page 863

Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
Usage Guidelines
The undebug platform ip multicast command is the same as the no debug platform ip multicast
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
OL-12248-01
Description
Displays information about the types of debugging that are enabled.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
debug platform ip multicast
B-39