Cisco Catalyst 3120 Command Reference Manual page 268

logging file
Command History Release
12.2(40)EX
Usage Guidelines
The log file is stored in ASCII text format in an internal buffer on a standalone switch, and in the case
of a switch stack, on the stack master. If a standalone switch or the stack master fails, the log is lost
unless you had previously saved it to flash memory by using the logging file flash:filename global
configuration command.
After saving the log to flash memory by using the logging file flash:filename global configuration
command, you can use the more flash:filename privileged EXEC command to display its contents.
The command rejects the minimum file size if it is greater than the maximum file size minus 1024; the
minimum file size then becomes the maximum file size minus 1024.
Specifying a level causes messages at that level and numerically lower levels to be displayed.
Examples
This example shows how to save informational log messages to a file in flash memory:
Switch(config)# logging file flash:logfile informational
You can verify your setting by entering the show running-config privileged EXEC command.
Related Commands Command
show running-config
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-240
Chapter 2
Modification
This command was introduced.
Description
Displays the operating configuration. For syntax information, use this
link to the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_comma
nd_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate
to the command.
Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
OL-12248-01