Ip Igmp Filter - Cisco Catalyst 3120 Command Reference Manual

ip igmp filter

ip igmp filter
Use the ip igmp filter interface configuration command on the switch stack or on a standalone switch
to control whether or not all hosts on a Layer 2 interface can join one or more IP multicast groups by
applying an Internet Group Management Protocol (IGMP) profile to the interface. Use the no form of
this command to remove the specified profile from the interface.
Syntax Description
profile number
Defaults
No IGMP filters are applied.
Command Modes
Interface configuration
Command History Release
12.2(40)EX
Usage Guidelines
You can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routed
ports, switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group.
An IGMP profile can be applied to one or more switch port interfaces, but one port can have only one
profile applied to it.
Examples
This example shows how to apply IGMP profile 22 to a port:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip igmp filter 22
You can verify your setting by using the show running-config privileged EXEC command and by
specifying an interface.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-178
ip igmp filter profile number
no ip igmp filter
The IGMP profile number to be applied. The range is 1 to 4294967295.
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
OL-12248-01