Radius-Server Host - Cisco Catalyst 3120 Command Reference Manual

Catalyst blade switch 3120 for hp command reference
Hide thumbs Also See for Catalyst 3120:
Table of Contents

Advertisement

Chapter 2
Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

radius-server host

Use the radius-server host global configuration command on the switch stack or on a standalone switch
to configure the RADIUS server parameters, including the RADIUS accounting and authentication. Use
the no form of this command to return to the default settings.
Syntax Description
ip-address
acct-port udp-port
auth-port udp-port
key string
test username name
idle-time time
ignore-acct-port
ignore-auth-port
Defaults
The UDP port for the RADIUS accounting server is 1646.
The UDP port for the RADIUS authentication server is 1645.
Automatic server testing is disabled.
The idle time is 60 minutes (1 hour).
When the automatic testing is enabled, testing occurs on the accounting and authentication UDP ports.
The authentication and encryption key (string) is not configured.
Command Modes
Global configuration
Command History
Release
12.2(40)EX
OL-12248-01
radius-server host ip-address [acct-port udp-port] [auth-port udp-port][test username name
[idle-time time] [ignore-acct-port] [ignore-auth-port]] [key string]
no radius-server host ip-address
Specify the IP address of the RADIUS server.
(Optional) Specify the UDP port for the RADIUS accounting server. The
range is from 0 to 65536.
(Optional) Specify the UDP port for the RADIUS authentication server. The
range is from 0 to 65536.
(Optional) Specify the authentication and encryption key for all RADIUS
communication between the switch and the RADIUS daemon. The key is a
text string that must match the encryption key used on the RADIUS server.
Always configure the key as the last item in this command. Leading spaces
are ignored, but spaces within and at the end of the key are used. If there are
spaces in your key, do not enclose the key in quotation marks unless the
quotation marks are part of the key.
(Optional) Enable automatic server testing of the RADIUS server status, and
specify the username to be used.
(Optional) Set the interval of time in minutes after which the switch sends test
packets to the server. The range is from 1 to 35791 minutes.
(Optional) Disables testing on the RADIUS-server accounting port.
(Optional) Disables testing on the RADIUS-server authentication port.
Modification
This command was introduced.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
radius-server host
2-355

Advertisement

Table of Contents
loading

Table of Contents