Installing The Fixed Cinewide Base Plate (D-73D/Cinewide); D-73D/Cinewide With Whitney Anamorphic Lens Base Plate - Exploded View - Runco D-73d Ultra Installation & Operation Manual

Installation
Installing the Fixed
CineWide Base Plate
(D-73d/CineWide)
D-73d/CineWide with Whitney Anamorphic Lens: Figure 3-9 shows the Whitney
anamorphic lens base plate assembly for a D-73d/CineWide.
The Whitney anamorphic lens cannot be used with the
Note D-73d Ultra.
2
Screw, Phillips
Pan-Head,
M5-0.8 x 10mm (2x)
Figure 3-9. D-73d/CineWide with Whitney Anamorphic Lens Base Plate -
Exploded View
To install the Whitney anamorphic lens base plate on a D-73d/CineWide:
1. Place the projector upside down on a blanket or other soft, flat surface.
2. Remove the two front feet from the projector.
3. Place the CineWide base plate on the bottom of the projector as shown.
4. Secure the base plate to the projector with the four (4) supplied, M5 x 0.8 x 10mm
Phillips screws.
DO NOT OVER-TIGHTEN THE SCREWS.
Caution
5. Re-attach the front feet to the projector.
34 D-73d Series Installation/Operation Manual
1 CineWide Base Plate
for Whitney Lens