Connecting The Active 3D Emitter To The Dimension Digital Controller; Connecting To Ac Power; Active 3D Emitter Connection - Runco LightStyle LS-12HBd Installation & Operation Manual

Connect the 3D SYNC Out port on the emitter to the 3D Sync Out connector on the
Dimension Digital Controller, as shown in Figure 3-21. Mount the emitter in a location that
provides a clear line of sight between it and the viewing area.
Secure the emitter in the desired location using double-sided tape or
Tip
a similar adhesive material.
Figure 3-21. Active 3D Emitter Connection
Projector: Plug the female end of one power cord into the AC receptacle on the rear of
the LS-12HBd (AC 100V ~ 240V). Then, connect the other end to your AC power source.
Anamorphic Lens Transport: An
AC-to-DC power adapter is provided for
the lens transport. Connect the power
adapter to the +9V DC In jack on the
rear of the lens transport assembly.
Connect the other end to an AC power
source.
Similarly connect the Dimension Digital Controller to a nearby AC outlet.
LightStyle™ LS-12HBd Installation/Operation Manual
3D SYNC
1 1
Component / SCART Component / SCART
HD1 HD1
Y Y
Pb Pb
DisplayPort r r DisplayPort
HD2 HD2
Active 3D Emitter
3D
SYNC IN
TRIGGERS TRIGGERS
USB USB
2 2 3 3
Video 1 Video 1 Video 2 Video 2
Video 3 Video 3
Pr Pr
HDMI 2 HDMI 2
49
Installation
Connecting the Active 3D
Emitter to the Dimension
Digital Controller

Connecting to AC Power