Connecting An External Ir Receiver To The Vx-22I; Connecting To Ac Power - Runco NLMP22109 Installation & Operation Manual

If infrared signals from the remote control cannot reach the projector due to excessive
distance or obstructions such as walls or cabinet doors, you can connect an external IR
receiver to the WIRED REMOTE input on the VX-22i to extend the range of the remote
control. See Figure 3-17.
IR Receiver
Remote
Control
Figure 3-17. External IR Receiver Connection
When an external IR receiver is connected to the wired IR input, the
Note
built-in IR sensor on the VX-22i is disabled.
Projector: Plug the female end of one power cord into the AC receptacle on the rear of
the VX-22i (AC 100V ~ 240V). Then, connect the other end to your AC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
The input voltage to the AutoScope lens motor must be between
Caution
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240 VAC power source!
Runco VX-22i Installation/Operation Manual
Ring = +5V
Tip = IR Input
WIRED REMOTE
Sleeve = Ground
(3.5-mm
Service port.
mini phono
plug)
Rear Panel
Not for user
access
35
Connecting an External IR
Receiver to the VX-22i

Connecting to AC Power