Connecting An External Ir Receiver; Connecting To Ac Power - Runco Quantum Color Q-750i Series Installation & Operation Manual

If infrared signals from the remote control cannot reach the projector due to excessive
distance or obstructions such as walls or cabinet doors, you can connect an external IR
repeater system to the IR INPUT on the Q-750i to extend the range of the remote control.
See Figure 3-16.
(3.5-mm, mini
phono plug)
Figure 3-16. External IR Receiver Connection
Projector: The Q-750i ships with various types of AC power cords. Choose the one that
is appropriate to your locale.
Plug the female end of the power cord into the AC receptacle on the rear of the projector
(AC 100V ~ 240V); see Figure 2-2. Then, connect the other end to your AC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
AutoScope Lens Motor (Rear)
Power
AC Input
Switch
Q-750i Series Installation/Operation Manual
IR Sensor Remote Control
IR Repeater
to
AC
Power
35
Installation
Connecting an External IR
Receiver

Connecting to AC Power