Mounting The Rs-1100; Floor Mounting; Ceiling Mounting; Adjusting The Projector Height Or Projection Angle - Runco RS-1100 CineWide Owner's Operating Manual

Installation
3.5

Mounting the RS-1100

Floor Mounting

Ceiling Mounting

Adjusting the Projector
Height or Projection Angle
There are several methods for mounting the projector. Depending on your chosen
installation, one method may be more suitable than another.
In typical front and rear screen installations, the projector can be mounted to a secure and
level surface such as a table or cart. Carts are useful when moving a projector during a
presentation or from site to site. If possible, lock the wheels when it's in position to prevent
it from being moved during a presentation.
The projector can also be inverted and suspended from the ceiling using a
specially-designed ceiling mount fixture. This type of mounting is recommended for fixed
installations and for those that want the projector out of sight or have a limited space for
projector and audience.
Use only the Runco-approved ceiling mount kit designed for your
Note
projector. Install the mount kit according to the instructions
provided with it.
If the screen is significantly higher or lower than the projector, you can also tilt the
projector at a slight angle. In a ceiling installation, you do this by adjusting the ceiling
mount.
For a floor installation, turn the four adjustable
feet on the bottom of the projector to adjust
the projector height and/or projection angle.
If you do this, you may need to make keystone
adjustments or vertically shift the image using
the on-screen display (OSD) controls, to
compensate. For detailed instructions, refer to
Using the On-Screen Menus on page 44.
24 Runco RS-1100 Series Owner's Operating Manual