Installation
Connecting to AC Power
Ethernet Network Connection: Use a standard, Category 5 network cable with an
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the DHD
Controller; see Figure 3-21. For more information about configuring and using this
connection, refer to Network on page 76.
RS-232
RS-232
To Accessory Box
To Accessory Box
HDMI 3
HDMI 3
HDMI 4
HDMI 4
to Ethernet
Hub, Router
or Gateway
Figure 3-21. Ethernet Network Connection to DHD Controller
Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the Q-750d Ultra (AC 100V ~ 240V). Then, connect the other
end to your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
Display Control
Display Control
IR
IR
HDMI Out
HDMI Out
To Display
To Display
HDMI Out
HDMI Out
Ethernet
Audio Only
Audio Only
42
Q-750d Ultra Series Installation/Operation Manual
1 Transmit Data +
2 Transmit Data -
3 Receive Data +
6 Receive Data -