Table of Contents
Advertisement
Installation
3.2
Quick Setup
Table 3-1 gives a quick overview of the Q-750d Ultra installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
Install primary projection lens
2
Install CineWide lens mounting assembly (stationary base
3
plate or AutoScope lens motor – optional)
Mount the projector
4
Connect the DHD Controller to the projector
5
Connect signal sources to the DHD Controller
6
Connect other external equipment to DHD Controller
(optional):
• Audio processor or secondary display device
• Automation/control system (RS-232)
7
• 12-volt trigger-activated equipment (AutoScope lens
motor, retractable screens or screen masking etc.)
• External IR repeater
• Network hub, router or gateway (Ethernet)
Connect projector, DHD Controller and lens motor (if
8
present) to AC power and power up
Adjust primary lens: projected image size (zoom), position
9
(shift) and focus; copy and paste settings as needed
For rear-screen and/or ceiling-mount installations, select
10
the proper picture orientation
Use Image Alignment controls to fine-tune image geometry
11
Install and adjust CineWide anamorphic lens (optional)
12
Display calibration: adjust the following for each input and
display mode (resolution and frame rate); save settings
when finished:
• Aspect ratio
• Brightness
13
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
Procedure
14
Q-750d Ultra Series Installation/Operation Manual
For Details, Refer to
page...
15
21
24
30
31
33
39
42
18, 44
44
45
47
55
Advertisement
Table of Contents
