Turning On The Power - Runco Q-750d Ultra Series Installation & Operation Manual

1. Turn on your source components.
2. Turn on the main power switch at the rear of the DHD Controller.
3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input.
4. Press the ON button on the remote control (or the ON/STANDBY (
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays "Initializing System," followed by
"Starting Q-750d Ultra." On the projector, the LED flashes green to indicate that it is
warming up.
5. When the projector is ready for use, the LED turns off. On the DHD Controller, the
fluorescent display indicates the active source, input resolution/frame rate and aspect
ratio/screen; for example:
Q-750d
16:9/1
Aspect Ratio/Screen
Q-750d Ultra Series Installation/Operation Manual
Current
Source
HDMI 1
1080i/60
1080p/60
Input Resolution/Frame Rate
) button on
43
Installation
3.8

Turning on the Power