Runco Q-750d Ultra Series Installation & Operation Manual page 91

Input Names: You can give each DHD Controller input a descriptive name. For example,
you may want to change the default input name to the type of source component
connected to it: "VCR," "DVD," "Laptop" et cetera. Input names can be up to 12
characters long.
To edit an input name, select Input Names from the Service menu. Press
an input and press ENTER. Use the
or to select a character to change. When you have finished editing the input name,
press ENTER or MENU.
To restore the default input name, press
"Restore" column. Then, press ENTER.
Display Device - Configure: The options in the Display Device - Configure menu allow
you to change the picture orientation or access other, display-device specific functions.
• Installation – Orientation: Select Installation from the Display Device - Configure
menu, then select Orientation to change the picture orientation to suit the method of
installation (Floor Front, Floor Rear, Ceiling Front or Ceiling Rear). Or, for
front-projection installations, use the Auto setting to have the projector automatically
determine the orientation (floor or ceiling) using an internal sensor.
• Display Info.: Select Display Info. from the Display Device - Configure menu to see the
projector serial number.
• Diagnostics: Select Diagnostics from the Display Device - Configure menu, then
select Red, Green, Blue, Yellow, Cyan or Magenta to display only that color channel
(simulating a filter of that color). This can be useful for calibration or measurement
purposes.
To restore the normal picture (all colors), select White.
• Altitude: Select Altitude from the Display Device - Configure menu to control the
operation of the projector's cooling fan.
In most cases, the default setting (Auto) will maintain the correct operating
temperature. If the projector frequently turns off due to overheating, or in certain
high-altitude operating environments, you may need to change this setting to High.
Q-750d Ultra Series Installation/Operation Manual
or buttons to change a character; press
repeatedly to highlight that input name in the
75
C o mp o s i t e
C o mp o s i t e
or to select
C o mp o s i t e
C o mp o n e n t
H D 1
H D 2
S C A R T
H D M I
H D M I
H D M I
H D M I
Operation
Input Names
Restore
1 Composite 1
2
Composite 2
3
Composite 3
Component
HD 1
HD 2
SCART
1 HDMI 1
2
HDMI 2
3
HDMI 3
4
HDMI 4