Table of Contents
Advertisement
Installation
3.2
Quick Setup
Table 3-1 gives a quick overview of the Q-1500d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step
1
Choose a location for the projector
2
Install CineWide lens mounting assembly (stationary base
plate or AutoScope lens motor – optional)
3
Mount the projector
4
Mount the Primary DHD Controller, Secondary DHD
Controller and Brightness Acceleration Engine
5
Connect the Primary and Secondary DHD Controllers to
the projector
6
Connect the Brightness Acceleration Engine to the Primary
and Secondary DHD Controllers
7
Connect other external equipment to Primary DHD
Controller (optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (retractable screens
or screen masking)
• External IR repeater
• Network hub, router or gateway (Ethernet)
8
Connect signal sources to the Brightness Acceleration
Engine
9
Connect system components to AC power
10
Power up the system and perform optical alignment
procedures (refer to Table 3-6)
11
Display calibration —Primary DHD Controller: set
Adjustment Mode to Primary; adjust the following for each
input and display mode (resolution and frame rate); save
settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
12
Display calibration —Secondary DHD Controller: set
Adjustment Mode to Secondary; repeat Step 11
Procedure
22
Q-1500d Series Installation/Operation Manual
For Details, Refer to
page...
23
31
36
37
38
40
42
46
50
51
67
67
Advertisement
Table of Contents
