Table of Contents
Advertisement
Installation
Connecting the AutoScope Lens Motor to the Projector: Connect the AutoScope
lens transport motor to the 12-volt trigger output on the projector (labeled
CINEWIDE/AUTOSCOPE), as shown in Figure 3-8.
PRIMARY
3.5-mm mini plug
SECONDARY
+12V
Power
AC Input
Trigger Input
Switch
Anamorphic Lens Transport Motor
Figure 3-8. Connecting the AutoScope Lens Motor to the Projector
After you have installed the AutoScope lens motor, proceed with Mounting the Q-1500d
(page 36).
Q-1500d Series Installation/Operation Manual
33
Advertisement
Table of Contents
