Shasta Anamorphic Lens Mounting Assembly - Exploded View - Runco QuantumColor Q-1500d series Installation & Operation Manual

1. Remove the two Yaw/X Adjustment Levers and Washers (5) from the bottom of the
Anamorphic Lens Holder (2).
2. Place the Anamorphic Lens Holder on top of (or under, if the projector is inverted) the
CineWide Base Plate. Position the bracket so that the slots at the bottom of the lens
holder are perpendicular to the corresponding slots on the base plate.
3. Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers (4) and
Yaw/X Adjustment Levers that you removed in Step 1.
4. Use the Height/Pitch Adjustment Knobs (3) to attach the Anamorphic Lenses (1) to
the Anamorphic Lens Holder.
To avoid clipping the corners of the image, position the anamorphic
Tip
lenses as close as possible to the primary lenses.
Q-1500d/CineWide or Q-1500d/CineWide with AutoScope - Shasta Anamorphic
Lens Installation: The Q-1500d "Shasta" Anamorphic lens mount kit consists of
everything shown in Figure 3-26.
Shasta Anamorphic
1
Lenses (2x)
AutoScope Lens
Motor Carriage Plate
(shown here) or Fixed
CineWide Base Plate
Figure 3-26. Shasta Anamorphic Lens Mounting Assembly - Exploded View
Q-1500d Series Installation/Operation Manual
2 Anamorphic Lens
Holder
3 4-40 Set Screw (4x)*
4
¼-20 Button-head
Pitch Adjustment
Screw (4x)*
5
¼-20 Button-head
Height Adjustment
Screw (8x)*
*Use included
L-wrench to tighten
¼-20 Hex Bolt
6
and Washer (2x)
Yaw/X-adjustment Lever
7
and Washer (2x)
57
Installation