Ethernet Network Connection To Primary Dhd Controller - Runco QuantumColor Q-1500d series Installation & Operation Manual

Ethernet Network Connection: Use a standard, Category 5 network cable with an
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the
Primary DHD Controller; see Figure 3-19.
For more information about configuring and using this connection, refer to Network on
page 88.
H H
HDMI 3 HDMI 3
HDMI 4 HDMI 4
to Ethernet
Hub, Router
or Gateway
Figure 3-19. Ethernet Network Connection to Primary DHD Controller
Q-1500d Series Installation/Operation Manual
Display Control Display Control
IR IR
HDMI Out HDMI Out
To Display To Display
RS232 RS232
PC / Control PC / Control
HDMI Out HDMI Out
Ethernet
Audio Only Audio Only
1 Transmit Data +
2 Transmit Data -
3 Receive Data +
6 Receive Data -
45
Installation