Table of Contents
Advertisement
Installation
Adjusting the Focus,
Zoom and Position of the
Primary Lenses
3. Turn on the main power switch at the rear of each DHD Controller and the Brightness
Acceleration Engine.
Leave the AC power switch on the anamorphic lens transport in the
Note
"off" position for now.
4. Press the ON button on the remote control (or the ON/STANDBY (
Primary DHD Controller front panel) to turn on the system. The vacuum fluorescent
display on the Primary DHD Controller front panel briefly displays "Initializing System,"
followed by "Starting Q-1500d."
5. When the display is ready for use, the fluorescent display indicates the active source,
input resolution/frame rate and aspect ratio; for example:
Q-1500d
16:9
Aspect Ratio
6. Select the HDMI 1 source using either the DHD Controller remote control unit (see
Figure 2-8) or the OSD menu (press MENU, then select Input Source -> HDMI 1).
Proceed as follows to adjust the top and bottom primary lenses for optimum image
quality.
Top Primary Lens Adjustment:
1. On the DHD Controller remote control or front panel, press MENU.
2. Select Calibration from the Main Menu and enter the Calibration Menu passcode.
You must enter a passcode to access the Calibration menu.
Note
3. Select Adjustment Mode from the Calibration Menu and set it to Primary.
4. Press EXIT (or MENU) repeatedly to return to the Main Menu.
5. Select Service from the Main Menu.
6. Select Test Video from the Service Menu and
choose Primary Alignment.
Current
Source
HDMI 1
1080i/60
1080p/60
Input Resolution/Frame Rate
54
Q-1500d Series Installation/Operation Manual
) button on the
Advertisement
Table of Contents
