Using Hdmi Cec Messages; Cec Command List - Runco QuantumColor Q-1500d series Installation & Operation Manual

The DHD Controller accepts and can respond to CEC command messages from a disc
player, satellite receiver or DVR/set-top box via an HDMI connection. Using CEC, the DHD
Controller can perform the following actions:
• Turn itself and the display device on and select the correct input when the source
component initiates playback of a disc or recorded program.
• Turn the source component on when you switch to its corresponding input on the DHD
Controller.
• Turn the source component off when the DHD Controller is turned off (unless the
source component is in playback mode).
• Change its OSD language when a similar change is made at the source.
To use CEC, connect your CEC-compatible sources to the HDMI inputs on the Q-1500d.
Set the CEC option to On (refer to CEC on page 93). Additional steps may be needed to
enable CEC at the source. Refer to the documentation for your source device for more
information.
Table 6-3 lists the CEC commands supported by the DHD Controller.
Table 6-3. CEC Commands Supported by the DHD Controller
Opcode
Feature Abort
Standby
Routing Change
Routing Information
Active Source
Request Active Source
Device Vendor ID
Give Device Vendor ID
Vendor Command With ID
Polling Message
Text View On
Report Physical Address
Inactive Source
CEC Version
Set OSD Name
Menu Status
Report Power Status
Set Menu Language
Q-1500d Series Installation/Operation Manual
Supported? (√ = Yes, – = No)
Value
Initiator
√
0x00
√
0x36
√
0x80
√
0x81
√
0x82
√
0x85
√
0x87
√
0x8C
√
0xA0
√
N/A
√
0x0D
√
0x84
√
0x9D
√
0x9E
√
0x47
√
0x8E
√
0x90
0x32
–
Follower
√
√
√
√
√
√
√
√
√
√
–
–
–
–
–
–
–
√
121
External Control
6.3
Using HDMI CEC
Messages

CEC Command List