Backup Save; Backup Delete - Roland SPD-S Owner's Manual

BACKUP SAVE

Here's how to save backup data (SPD-S settings: patch, wave, setup) to a memory card. A maximum of four backup data sets can
be saved on a card.
If there is not enough free memory on a card, it will only be able to store a limited number of backup data sets.
1. Set the following parameter.
Press [-]/[+] to change the value.
Parameter Value
Save 1–4
2. Press [>] to display "sure?" Give a name to the backup data.
The initial value is Backup*. The final character (*) is the number specified in Step 1.
Press the PAGE buttons to move the cursor under the name and press [-]/[+] to change the character at the cursor position.
When the name is complete, press [ENTER] to save it.
While saving is in progress, "now processing.." is displayed. Afterwards, the SPD-S returns to the original mode.
Do not power the unit off during execution.

BACKUP DELETE

This procedure allows you to delete backup data (SPD-S settings: patch, wave, setup) on a memory card.
1. Set the following parameter.
Press [-]/[+] to change the value.
Parameter Value
Delete 1–4
2. Press [>] to display "delete, sure?" Press [ENTER] to delete the backup data set.
While deleting is in progress, "now processing.." is displayed. Afterwards, the SPD-S returns to the original mode.
Do not power the unit off during execution.
Descriptions
Select the destination number to which the backup data is to be saved.
* By pressing [SHIFT] and [FUNC], you can select a new (empty) destination number.
Descriptions
Specify the backup data set to be deleted.
Chapter 6 Using a CompactFlash Memory Card
73