Roland SPD-S Owner's Manual page 96

Effect List
3: STEREODELAY (Stereo Delay)
Adds a delay in stereo to the original sound to produce a fat sound or special effects.
When FbkMode is NORMAL
2-Band
L in
EQ
2-Band
R in
EQ
Parameter Value
EQ Low -12.0–+12.0 dB
EQ High -12.0–+12.0 dB
DelayL 1.5–2000 ms
DelayR
Feedback -98–+98%
FbkMode NORMAL, CROSS
PhaseL NORMAL, INVERSE
PhaseR
LF Damp THRU, 50–4000 Hz
HF Damp 200 Hz–12.5 kHz, THRU
DelayLevel 0–127
In addition, if you press the PAGE buttons, "Knob," "Velo" and "Pedal" are displayed. You can then select the parameters to be
controlled with the EFFECTS CONTROL knob, the strength (velocity) used in hitting a playing surface, and the expression pedal.
Value Parameters controlled with Knob, Velo and Pedal
(See the table above for details.)
OFF —
DELAYTIME DelayL, DelayR
FEEDBACK Feedback
DELAYLEVEL DelayLevel
96
L out
Delay
DelayLevel
Feedback
Feedback
DelayLevel
Delay
R out
Descriptions
Low frequency amplification/attenuation
High frequency amplification/attenuation
Delay time from the start of the original sound to the start of the delay sound both
on L and R channels
Rate at which the delay sound is fed back (Negative: reversed phase)
Destination into which the delay sound is fed back (See the diagram)
Phase of the delay sound on L/R channel
NORMAL: non-inversed phase
INVERSE: inversed phase
Cutoff frequency for low frequency damping (THRU: no damping)
Cutoff frequency for high frequency damping (THRU: no damping)
Volume level of the delay sound
When FbkMode is CROSS
2-Band
L in
EQ
2-Band
R in
EQ
Descriptions
—
The delay time is controlled on both L and R channels
at the same time.
* When you control them, noise may be produced.
—
—
L out
Delay
DelayLevel
Feedback
Feedback
DelayLevel
Delay
R out