Roland SPD-S Owner's Manual page 55

7
Press the PAGE buttons to set the following parameters. Press the
PAGE buttons to change the parameter, and press [-]/[+] to change the
value.
See p. 58 for details on the parameters.
• StartLvl (Start Level)
• Mode
• Grade
• Type
When Type is set to PHRASE, set the following parameters as well.
• Tempo
• Beat
• Click Level
8
Press [START/STOP] to start sampling.
•When StartLvl is set to OFF in Step 7
Sampling starts immediately. Start the performance of the device connected
to the INPUT jacks. "Rec" is displayed while sampling is in progress.
•When StartLvl is set to anything other than OFF in Step 7
"Wait.." appears and the SPD-S enters standby mode. Start the performance
of the device connected to the INPUT jacks. An input signal that is higher in
level than the value set in StartLvl triggers sampling. Alternatively, press
[START/STOP] again to start sampling. "Rec" is displayed while sampling is
in progress.
9
When the performance is finished, press [START/STOP] to finish
sampling.
10
A "write?" indication is displayed and you can name the wave. Press
the PAGE buttons to move the cursor under the name characters and
press [-]/[+] to change them. When the name is complete, press
[ENTER] to save it.
A "now writing.." indication appears until the wave is saved.
If you do not want to save the wave, press [EXIT], and you will return to the "Stby" (Standby)
screen in Step 6.
Chapter 3 Sampling
The parameters listed on the
left return to their respective
initial values when sampling is
finished.
Do not power the SPD-S off
while sampling is in progress.
If you press [START/STOP] or
hit a pad, you can listen the
sampled sound.
Do not power the SPD-S off
while saving a wave.
55