Wave Utilities Parameters; Wave Truncate; Wave Pitch - Roland SPD-S Owner's Manual

Wave Utilities Parameters

WAVE TRUNCATE

This preserves the wave between the start and end points specified in START/END POINT in Wave Edit, and deletes the rest
permanently (conserving memory).
After executing the truncation, the wave cannot be restored to its original state.
1. "[>] to truncate" is displayed. Press [>].
2. A "truncate, sure?" indication appears. Press [ENTER] to execute truncation, or press [<] to return to
Step 1.
After execution, a "complete!" indication appears and the SPD-S returns to the wave mode.

WAVE PITCH

Create a new wave with the PITCH changed keeping the original wave intact.
1. Set the following parameters.
Press the PAGE buttons to change the parameter and press [-]/[+] to change the value.
Parameter Value
Pitch 50–200%
Dst
I001–399,
(Destina-
C001–500
tion)
If the pitch is changed, there may be some outstanding noise.
2. Press [>] to display "sure?" Here, you can name the new wave. Press the PAGE buttons to move the
cursor below the name characters and press [-]/[+] to change them. When you have finished entering
the name, press [ENTER] to save it.
While saving is in progress, "now processing.." is displayed. After saving, "complete!" appears and the SPD-S returns to the
wave mode.
While saving is in progress, do not power the unit off.
Descriptions
Define the pitch. Above 100%, the pitch is raised. Below 100%, the pitch is lowered.
* Press [START/STOP] or hit a pad to listen and verify how the wave sounds. The sounds
are played back monaurally (over the left channel only). In this event, Loop and Reverse
(Loop and Reverse in WAVE SETUP in Wave Edit -> p. 46) are temporarily switched to
OFF.
Choose the wave number to which the new wave is to be saved.
I001–399: To the internal memory
C001–500: To the memory card
* By pressing [CARD], you can select the top number of the internal memory or of the mem-
ory card.
* If you press [SHIFT] and [FUNC], a new (empty) wave number is automatically selected.
* While continuing to hold down [FUNC], the remaining capacity of the memory (Remain)
is shown.
Chapter 2 Wave Editing
49