Roland SPD-S Owner's Manual page 95

2: DLYEDREVERB (Delayed Reverb)
Adds a delay before reverb to delay the reverb sound.
fig.DelayedReverb.eps
2-Band
L in
EQ
Feedback
2-Band
R in
EQ
Parameter Value
EQ Low -12.0–+12.0 dB
EQ High -12.0–+12.0 dB
DlyTime 1.5–2000 ms
DlyFeedBak -98–+98 %
LowCut THRU,
50–4000 Hz
RevType HALL,
ROOM,
PLATE
RevTime 0.1–10.0 s
LF Damp THRU,
50–4000 Hz
HF Damp 1000 Hz–12.5 kHz,
THRU
ReverbLevel 0–127
In addition, if you press the PAGE buttons, "Knob," "Velo" and "Pedal" are displayed. You can then select the parameters to be
controlled with the EFFECTS CONTROL knob, the strength (velocity) used in hitting a playing surface, and the expression pedal.
Value Parameters controlled with Knob and Pedal
(See the table above for details.)
OFF —
DELAYTIME DlyTime
DLYFEEDBAK DlyFeedBak
REVTIME RevTime
REVERBLEV ReverbLevel
WIDE RevTime, HF Damp, ReverbLevel
Value Parameters controlled with Velo
(See the table above for details.)
OFF —
DLYFEEDBAK DlyFeedBak
REVTIME RevTime
REVERBLEV ReverbLevel
RVTIME+LEV RevTime, ReverbLevel
RESOTUNE DlyTime, DlyFeedBak
Low Cut
Delay Reverb
Filter
Descriptions
Low frequency amplification/attenuation
High frequency amplification/attenuation
Delay time from the start of the original sound to the start of the delay sound
Rate at which the delay sound is fed back (Negative: reversed phase)
Frequency below which the delay sound fed back to the reverb is cut off (THRU: the low
cut filter disabled)
HALL: reverb simulating a concert hall
ROOM: reverb simulating a room
PLATE: reverb simulating a metal-plate reverb unit
Duration of the reverb
Cutoff frequency for low frequency damping (THRU: no damping)
Cutoff frequency for high frequency damping (THRU: no damping)
Volume level of the reverb
L out
ReverbLevel
R out
Descriptions
—
—
—
—
—
The overall reverb effect is controlled.
Descriptions
—
—
—
—
The reverb gets deeper as strike force increases.
Produces a special reverb sound, the pitch of which varies
depending on the strike force.
Effect List
95