Dualwatch Operation - Icom IC-7600 Instruction Manual

4
RECEIVE AND TRANSMIT

■ Dualwatch operation

Dualwatch montors 2 frequences wth the same
mode smultaneously.
Durng dualwatch, both frequences should be on the
same band, because the bandpass flter n the RF cr-
cut s selected for the man readout frequency.
q Set a desred frequency nto the man band.
w Push and hold [DUALWATCH] for 1 sec.
• " " appears.
• The sub readout operatng mode s equalzed to the
man readout.
• Equalzed receve frequency appears on the sub band
frequency readout. Ths quck dualwatch functon can
be turned OFF n the Others set mode. (p. 128)
• Pushng [DUALWATCH] momentarly actvates the
dualwatch wth the prevously operated frequency.
e Rotate the man dal to set another desred fre-
quency.
r Push [MAIN/SUB M.SCOPE] to enables the sub
band access when changng the frequency, etc. n
sub band.
• Push [MAIN/SUB M.SCOPE] agan for the man band
access.
t Adjust the [BAL] control to set a sutable sgnal
strength balance between the man and sub read-
out frequences.
• S-meter shows the combned sgnal strength.
y To transmt on the sub readout frequency, push
[CHANGE] or [SPLIT].
NOTE:
• A beat note may be heard dependng on the fre-
quency combnaton.
• The RIT functon can be used for the man read-
out only.
• The ∂TX functon can be used for the transmt
readout (man readout when the splt functon
OFF; sub readout when the splt functon ON).
79
DUAL
WATCH
[BAL] control
M.SCOPE M.SCOPE
SPLIT CHANGE
Main dial
MAIN
/SUB
Appears