Other Connectors - Foxconn 600A01 series User Manual

Other Connectors

This motherboard includes connectors for FDD, IDE HDD, USB, CPU fan, system
fan, and others.
FDD Connector: FLOPPY
This motherboard includes a standard FDD connector, supporting 360K, 720K,
1.2M, 1.44M and 2.88M FDDs.
HDD Connectors: PIDE & SIDE
The connectors support the provided UltraDMA 133/100/66/33 IDE hard disk
r i b b o n c a b l e . C o n n e c t t h e c a b l e ' s b l u e c o n n e c t o r t o t h e p r i m a r y
(recommended) or secondary IDE connector, then connect the gray connec-
tor to the Ultra DMA 133/100/66/33 slave device (hard disk drive) and the black
connector to the Ultra DMA 133/100/66/33 master device. If you install two hard
disks, you must configure the second drive as a slave device by setting its
jumper accordingly. Refer to the hard disk documentation for the jumper
settings.
Attention:
Ribbon cables are directional, therefore, make sure to always
connect with the cable on the same side as pin 1 of the PIDE/
SIDE or FDD connector on the motherboard.
600A01-FOXCONN-V1.0-HW-en.p65
Chapter 2
600A01 Series User Manual
19
Installation Instructions
1
FDD connector
2004-4-12, 13:30
19