Foxconn 600A01 series User Manual page 15

9
IDE connectors
These dual-channel bus master IDE connectors support Ultra DMA 133/
100/66/33 devices. Both the primary (blue) and secondary (white)
connectors are slotted to prevent incorrect insertion of the IDE ribbon cable.
10
Floppy disk connector
This connector accommodates the provided ribbon cable for the floppy disk
drive. One side of the connector is slotted to prevent incorrect insertion of
the floppy disk cable.
11
PCI slots
These five 32-bit PCI 2.2 expansion slots support bus master PCI cards
like SCSI or LAN cards with 133MB/s maximum throughput.
12
CNR slot (optional)
This slot is specifically designed for the Communication and Networking
Riser (CNR) card. The CNR supports V.90 analog modem only.
13
Flash Rom
This 4Mb firmware contains the programmable BIOS program.
14 Audio CODEC
The VIA VT1616 provides 6-channel outputs fully supporting surround sound
applications, along with 4 stereo and 2 mono inputs. Supporting the AC'97
2.2 specification, the VIA VT1616 enables 20-bit resolution, and a variable
sampling rate with 1Hz resolution.
15
1394 controller (optional)
VT6307 is the controller for IEEE1394a on motherboard. The VT6307 is a
complete small package single chip PCI solution at 400Mbps, low power
seamless plug and play connections to the latest IEEE 1394 enabled
devices.
16
10/100M LAN PHY
The VT6103L is a single-port PHY transceiver with an MII (Media
Independent Interface) and supports 10/100 Mbps data transfer rate.
600A01-FOXCONN-V1.0-HW-en.p65
Chapter 1
600A01 Series User Manual
7
Product Introduction
2004-4-12, 13:29
7