Table of Contents
Advertisement
Other Connectors
This motherboard includes connectors for FDD, IDE HDD, USB, CPU fan, system
fan and others.
FDD Connector
This motherboard includes a standard FDD connector, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
HDD connectors: PIDE & SIDE
These connectors supports the Ultra DMA 133/100/66 IDE hard disk ribbon
cable. Connect the cable's blue connector to the primary (recommended) or sec-
ondary IDE connector, then connect the gray connector to the Ultra DMA 133/
100/66 slave device (hard disk drive) and the black connector to the Ultra DMA
133/100/66 master device. If you install two hard disks, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer to the hard
disk documentation for the jumper settings.
Attention:
Ribbon cables are directional, therefore, make sure to
always connect with the cable on the same side as pin 1 of the
PIDE/SIDE or FDD connector on the motherboard.
14
Chapter 2
Installation Instructions
Advertisement
Table of Contents
