Foxconn 600A01 series User Manual page 33

Serial ATA Connectors: SATA_1, SATA_2 (optional)
The Serial ATA header is used to connect the Serial ATA device to the
motherboard. These connectors support the thin Serial ATA cables for primary
internal storage devices. The current Serial ATA interface allows up to 150MB/s
data transfer rate, faster than the standard parallel ATA with 133MB/s (Ultra ATA/
133).
Audio Interface: F_AUDIO
The audio interface provides two kinds of audio output choices: the Front Audio,
the Rear Audio. Their priority is sequenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the front panel of the chassis (using the
Front Audio), then the Line-out (Rear Audio) on the rear panel will not work. If you
do not want to use the Front Audio, pin 5 and 6, pin9 and 10 must be short, and
then the signal will be sent to the rear audio port.
600A01-FOXCONN-V1.0-HW-en.p65
Chapter 2
600A01 Series User Manual
25
Installation Instructions
GND
RX+
RX-
GND
TX-
TX+
GND
SATA_1/SATA_2
1
MIC_IN MIC_GND
MIC_PWR
+5VA
RET_R
OUT-R
Empty
NC
RET_L
OUT_L
F_AUDIO
2004-4-12, 13:30
25