Table of Contents
Advertisement
example, if you select Minor, you receive all Minor, Major and Critical messages. If you select
Major you receive all Major and Critical messages. The default is Information.
3 Click Apply.
4 From the Altitude AP Log Level drop-down list, select the least severe log level for the AP that you
want to receive: Information, Minor, Major, Critical. The default is Critical.
5 Click Apply.
To set a poll interval:
1 From the main menu, click Summit Switch. The Summit Switch Configuration screen is displayed.
2 From the left pane, click System Maintenance. The System Maintenance screen is displayed.
3 In the Health Checking section, in the Poll Timer box, type the time interval (in seconds) for the
Summit WM Controller to check that each Wireless AP is connected. The default is 60 seconds.
4 Click Apply.
To enable and define parameters for Syslog:
1 From the main menu, click Summit Switch. The Summit Switch Configuration screen is displayed.
2 From the left pane, click System Maintenance. The System Maintenance screen is displayed.
3 In the Syslog section, to enable the Syslog function for up to three syslog servers, select the
appropriate checkboxes.
4 For each enabled syslog server, in the IP box, type a valid IP address for the server on the network.
5 For each enabled syslog server, in the Port # box, type a valid port number to connect on. The
default port for syslog is 514.
6 To include all system messages, select the Include all service messages checkbox. If the box is not
selected, only component messages (logs and traces) are relayed. This setting applies to all three
servers. The additional service messages are:
DHCP messages reporting users receiving IP addresses
●
Startup Manager Task messages reporting component startup and failure
●
7 To include audit messages, select the Include audit messages checkbox.
8 From the Application Logs drop-down list, select the log level (local.0 - local.6) to be sent to the
syslog server. This setting applies all three servers.
9 If the Include all service messages checkbox is selected, the Service Logs drop-down list becomes
selectable. Select the log level (local.0 - local.6) to be sent to the syslog server. This setting applies all
three servers.
10 If you selected the Include audit messages checkbox, the Audit Logs drop-down list becomes
available. Select the log level (local.0 - local.6) to be sent to the syslog server. This setting applies all
three servers.
11 To apply your changes, click on the Apply button.
NOTE
The syslog daemon must be running on both the Summit WM Controller and on the remote syslog server before
the logs can be synchronized. If you change the log level on the Summit WM Controller, you must also modify
the appropriate setting in the syslog configuration on remote syslog server.
Summit WM20 User Guide, Software Release 4.2
Performing System Maintenance Tasks
201
Advertisement
Table of Contents
