Extreme Networks Summit WM20 User Manual page 193

HW – Hardware version of the Wireless AP.
●
SW – Software version executing on theWireless AP.
●
TA – Telnet access (enabled or disabled).
●
BD – Broadcast disassociation (enabled or disabled). If enabled, whenever the Wireless AP is going
●
offline in a controlled fashion it will send the disassociation frame to all its clients as a broadcast.
DV – Diversity
●
P/To – Poll timeout. If polling is enabled, a numeric value.
●
P/I – Poll interval. If polling is enabled, a numeric value.
●
Wired MAC – The physical address of the Wireless AP's wired Ethernet interface.
●
Description – As defined on the AP Properties screen.
●
Failure Maintn. – Maintain MU sessions on Wireless AP when the Wireless AP loses the connection
●
to the Summit WM Controller.
Assn – Assignment (address assignment method)
●
Static Cfg – Wireless AP's IP address if statically configured (same as the Static Values radio button
●
on the AP Static Configuration screen).
Static Cfg IP – Statically Configured IP. If the Wireless AP's IP address is configured statically, the
●
IP address is displayed.
Netmask – If the Wireless AP's IP address is configured statically, the netmask that is statically
●
configured for the Wireless AP.
Gateway – If the Wireless AP's IP address is configured statically, the IP address of the gateway
●
router that the Wireless AP will use.
SWM Search List – The list of IP addresses that the Wireless AP is configured to try to connect to in
●
the event that the current connection to the Summit WM Controller is lost.
To export and save a report in XML:
1 On the report screen, click Export. A Windows File Download dialog is displayed.
2 Click the Save button. A Windows Save As dialog is displayed.
NOTE
If your default XML viewer is Internet Explorer or Netscape, clicking Open will open the exported data to your
display screen. You must right-click to go back to the export display. The XML data file will not be saved to your
local drive.
3 Browse to the location where you want to save the exported XML data file, and in the File name box
enter an appropriate name for the file.
4 Click Save. The XML data file is saved in the specified location.
Summit WM20 User Guide, Software Release 4.2
Viewing Reports
193