Disconnecting A Telnet Session; Controlling Telnet Access - Extreme Networks ExtremeWare 7.2e Installation And User Manual

6 Configure the default route for the switch using the following command:
configure iproute add default <gateway> {<metric>}
For example:
configure iproute add default 123.45.67.1
7 Save your configuration changes so that they will be in effect after the next switch reboot, by using
the following command:
save configuration {primary | secondary}
8 When you are finished using the facility, log out of the switch by typing:
or
logout

Disconnecting a Telnet Session

An administrator-level account can disconnect a Telnet management session. If this happens, the user
logged in by way of the Telnet connection is notified that the session has been terminated.
To terminate a Telnet session, follow these steps:
1 Log in to the switch with administrator privileges.
2 Determine the session number of the session you want to terminate by using the following
command:
show session
3 Terminate the session by using the following command:
clear session <number>

Controlling Telnet Access

By default, Telnet services are enabled on the switch. Telnet access can be restricted by the use of an
access profile. An access profile permits or denies a named list of IP addresses and subnet masks. To
configure Telnet to use an access profile, use the following command:
enable telnet {access-profile [<access_profile> | none]} {port <tcp_port_number>}
Use the
none
To display the status of Telnet, use the following command:
show management
You can choose to disable Telnet by using the following command:
disable telnet
To re-enable Telnet on the switch, at the console port use the following:
enable telnet
You must be logged in as an administrator to enable or disable Telnet.
NOTE
For more information on Access Profiles, see Chapter 9.
ExtremeWare 7.2e Installation and User Guide
quit
option to remove a previously configured access profile.
Using Telnet
51