Extreme Networks ExtremeWare 7.2e Installation And User Manual page 241

Route Re-Distribution
Re-Distributing Routes into OSPF
Enable or disable the exporting of RIP, static, and direct (interface) routes to OSPF using the following
commands:
enable ospf export [direct | rip | static] [cost <number> [ase-type-1 | ase-type-2]
{tag <number>}]
These commands enable or disable the exporting of RIP, static, and direct routes by way of LSA to other
OSPF routers as AS-external type 1 or type 2 routes. The default setting is disabled.
The cost metric is inserted for all RIP, static, and direct routes injected into OSPF. If the cost metric is set
to 0, the cost is inserted from the route. The tag value is used only by special routing applications. Use 0
if you do not have specific requirements for using a tag. The tag value in this instance has no
relationship with 802.1Q VLAN tagging.
The same cost, type, and tag values can be inserted for all the export routes, or route maps can be used
for selective insertion. When a route map is associated with the export command, the route map is
applied on every exported route. The exported routes can also be filtered using route maps. Routes
filtered with a route map will be exported as ase-type-1.
Enable or disable the export of virtual IP addresses to other OSPF routers using the following
commands:
enable ospf export [direct | rip | static] [cost <number> [ase-type-1 | ase-type-2]
{tag <number>}]
disable ospf export [direct | rip | static]
Verify the configuration using the command:
show ospf
Previous Release Issues with OSPF Re-Distribution
In versions of ExtremeWare prior to release 6.0, direct routes corresponding to the interfaces on which
RIP was enabled were exported into OSPF as part of RIP routes, using the command
enable ospf
. Using ExtremeWare 6.0 and above, you must configure ExtremeWare to export these direct
export rip
routes to OSPF. You can use an access profile to filter unnecessary direct routes, using the command:
configure ospf direct-filter
Re-Distributing Routes into RIP
Enable or disable the exporting of static, direct, and OSPF-learned routes into the RIP domain using the
following commands:
disable rip export [direct | | ospf | ospf-extern1 | ospf-extern2 | ospf-inter |
ospf-intra | static]
disable rip export [direct | | ospf | ospf-extern1 | ospf-extern2 | ospf-inter |
ospf-intra | static]
These commands enable or disable the exporting of static, direct, and OSPF-learned routes into the RIP
domain. You can choose which types of OSPF routes are injected, or you can simply choose , which
ospf
will inject all learned OSPF routes regardless of type. The default setting is disabled.
ExtremeWare 7.2e Installation and User Guide 241