Rip Configuration Example; Configuring Ospf; Configuring Ospf Wait Interval - Extreme Networks ExtremeWare 7.2e Installation And User Manual

Interior Gateway Protocols

RIP Configuration Example

A switch that has three VLANs is defined as follows:
• Finance
— Contain ports 5 and 6.
— IP address 192.207.35.1.
• Personnel
— Contain ports 22 and 23.
— IP address 192.207.36.1.
In this configuration, all IP traffic from stations connected to ports 5 and 6 have access to the switch by
way of the VLAN Finance. Ports 22 and 23 reach the switch by way of the VLAN Personnel.
The example is configured as follows:
create vlan Finance
create vlan Personnel
configure Finance protocol ip
configure Personnel protocol ip
configure Finance add port 5, 6
configure Personnel add port 22, 23
configure Finance ipaddress 192.207.35.1
configure Personnel ipaddress 192.207.36.1
enable ipforwarding
configure rip add vlan all
enable rip

Configuring OSPF

Each switch that is configured to run OSPF must have a unique router ID. It is recommended that you
manually set the router ID of the switches participating in OSPF, instead of having the switch
automatically choose its router ID based on the highest interface IP address. Not performing this
configuration in larger, dynamic environments could result in an older link state database remaining in
use.

Configuring OSPF Wait Interval

ExtremeWare allows you to configure the OSPF wait interval, rather than using the router dead interval.
CAUTION
Do not configure OSPF timers unless you are comfortable exceeding OSPF specifications.
Non-standard settings might not be reliable under all circumstances.
To specify the timer intervals, use the following command:
242 ExtremeWare 7.2e Installation and User Guide