Ethernet Automatic Protection Switching
NOTE
The configuration of the Superbridge, SubBridge, and IP range control VLANs cannot be modified.
Enabling and Disabling an EAPS Domain
To enable a specific EAPS domain, use the following command:
enable eaps {<name>}
To disable a specific EAPS domain, use the following command:
disable eaps {<name>}
Enabling and Disabling EAPS
To enable the EAPS function for the entire switch, use the following command:
enable eaps
To disable the EAPS function for the entire switch, use the following command:
disable eaps
Unconfiguring an EAPS Ring Port
Unconfiguring an EAPS port sets its internal configuration state to INVALID, which causes the port to
appear in the Idle state with a port status of Unknown when you use the
command to display the status information about the port.
{detail}
To unconfigure an EAPS primary or secondary ring port for an EAPS domain, use the following
command:
unconfigure eaps <name> [primary | secondary] port
The following command example unconfigures this node's EAPS primary ring port on the domain
"eaps_1":
unconfigure eaps eaps_1 primary port
Displaying EAPS Status Information
To display EAPS status information, use the following command:
show eaps summary
The results for this command are as follows:
EAPS Enabled: Yes
Number of EAPS instances: 1
EAPSD-Bridge links: 2
Domain
State
------------
------------ -- -- ------- -------
eaps1
Complete
190
Pri
Sec
Mo En
Port
Port
M
Y
10
20
show eaps {<name>}
Vlan
Control-Vlan (VID) count
------------------ -----
cvlan
(0100)
ExtremeWare 7.2e Installation and User Guide
1