Snmp - Extreme Networks ExtremeWare 7.2e Installation And User Manual

• Set the Rx mode values for the selected VLANs. The pull-down menu allows you to specify the
following:
None—Do not receive packets on this interface.
Any—Receive packets on this interface in any mode.
V1 Only—Receive RIP v1 format packets to the broadcast address.
V2 Only—Receive RIP v2 format packets to the RIP multicast address.
If no VLAN is specified, the setting is applied to all VLANs. The default setting is V2 Only.
• Use the Unconfigure button to reset the RIP configuration for the VLAN to the default values.
• Use the Submit button to submit the changes to the system.

SNMP

The SNMP window is divided into two sections. The top section allows you to enter system group
information and authentication information for the community strings. The bottom section allows you
to set the configuration associated with SNMP traps.
System Group Configuration
As shown in Figure 67, this portion of the SNMP window allows you to set:
Contact —A text field that enables you to enter the contact information of the person responsible for
managing the switch.
Name—The system name is the name that you have assigned to this switch. The default name is the
model name of the switch (for example, Summit 400-48t switch).
Location —The location of this switch.
ExtremeWare 7.2e Installation and User Guide
Configuring the Summit 400 using ExtremeWare Vista
275