Browser Controls; Status Messages; Configuring The Summit 400 Using Extremeware Vista - Extreme Networks ExtremeWare 7.2e Installation And User Manual

When you choose a submenu link in the task frame, the content frame populates with the
corresponding data. However when you choose a new task, the content frame does not change until
you choose a new a submenu link and repopulate the frame.

Browser Controls

Browser controls include drop-down list boxes, check boxes, and multiselect list boxes. A multiselect list
box has a scrollbar on the right side of the box. Using a multiselect list box, you can select a single item,
all items, a set of contiguous items, or multiple noncontiguous items. Table 43 describes how to make
selections from a multiselect list box.
Table 43: Multiselect List Box Key Definitions
Selection Type
Single item
All items
Contiguous items
Selected noncontiguous items

Status Messages

Status messages are displayed at the top of the content frame. The four types of status messages are:
• Information—Displays information that is useful to know before, or as a result of, changing
configuration options.
• Warning—Displays warnings about the switch configuration.
• Error—Displays errors caused by incorrectly configured settings.
• Success—Displays informational messages after you click Submit. The message displayed reads,
"Request was submitted successfully." These informational messages indicate that the operation was
successful.
Standalone Buttons
At the bottom of some of the content frames is a section that contains standalone buttons. Standalone
buttons are used to perform tasks that are not associated with a particular configuration option. An
example of this is the Reboot Switch button.

Configuring the Summit 400 using ExtremeWare Vista

You can configure many features of the Summit 400-48. Click the Configuration button in the task frame
to reveal the submenu links, as shown in Figure 54. These configuration tasks are described in the
following sections:
• IP Forwarding on page 262
• License on page 263
• OSPF on page 264
• Ports on page 270
ExtremeWare 7.2e Installation and User Guide
Key Sequence
Click the item using the mouse.
Click the first item, and drag to the last item.
Click the first desired item, and drag to the last desired item.
Hold down [Ctrl], click the first desired item, click the next desired item, and
so on.
Configuring the Summit 400 using ExtremeWare Vista
261