Singer XL-6000 Instruction Manual page 90

1. Chant
of embroidery
frame.
Draw a horizontal
line at right angles
to vertical line
according to the
end of letters
2. Press the LCD Screen to
position the frame and
establish the needle entry
points "g" and "h" on the Y
axis Vertical line and "i" on the
X axis horizontal line.
* Points (Y axis
vertical line) must
be at least 5 cm
(2 inches] apart
\
27 I OperatiOn
of LCD screen for specifying needle entrY Points "g" °'h'! and "i"
_1. specifying point ,,g_
Touch screen at upper
part of vertical line.
1 This will move embroi-
dery frame.
Turn handwheel to check
that needle is positioned
2 directly above Y axis
vertical line.
Pressneedle positiondirection
arrowsso that needlepointis
directlyaboveY axisverticalline.
Foreach needleentrypoint, be
sureto turn handwheel t o lower
needleto verify that needlepoint
3 is directlyaboveY axisvertical
line.
Once needle entry point
is correctly specified on
the Y axis vertical line,
press position memory
4 [1] for the first point.
i
i:
_2; specifying point !ih_
Touch screen at lower
part of vertical line.
This will move embroi-
l dery frame.
S I
. , . ..........
cI
Turn handwheel to check
that needle is positioned
directly above Y axis
vertical line,
Press needle position direction
arrows so that needle point is
directly above Y axis vertical line.
For each needle entry point, be
sure to turn handwheel to lower
needle to verify that needle point
3 is directly above Y axis vertical
line
Once needle entry point
is correctly specified on
the Y axis vertical line,
press position memory
4 [2] for second point.
89